UV topcoat dispersant wetting and dispersing additive pigment wetting reduce viscosity

Anjeka 6111A Industrial coating Oil-Based high-filler viscosity reduction epoxy floor coating additives adhesive dispersant 

GENERAL DESCRIPTION

Anjeka-6111A improves pigment wetting and is a wetting and dispersing additive for solvent-borne and solvent-free coatings and inks to reduce the time required for the grinding process and to stabilize pigment dispersion. It is effective in stabilizing inorganic pigments, especially titanium dioxide, and effectively reduces the viscosity of the grinding slurry.

PRODUCT DATA

Chemical composition: Copolymer with acidic groups

Typical physical and chemical data:

The data given in this data sheet are typical values, not product specifications.

Appearance Yellow transparent liquid

Acid value (mg KOH/g) 40-120

Density g/cm³ (23℃) 1.00-1.20

Viscosity cps (25℃) 300-3000

Active ingredient (%) 100

STORAGE and TRANSPORT

Layering and turbidity may occur at temperatures below 10˚C. Heat to 20˚C and mix thoroughly before use.

Storage time is not recommended to exceed 12 months.

SPECIAL NOTES

This product should be stored in airtight containers and should not be re-stored after pre-dilution.

APPLICATION GUIDELINES

Coating Industry

Features and Benefits.

Anjeka-6111A is mainly used in high solids and solvent-free coatings. Due to its anionic properties, it is very suitable for acid-catalyzed systems (e.g. coil coatings). Anjeka-6111A stabilizes inorganic pigments, especially titanium dioxide, which increases gloss, reduces haze, and reduces the viscosity of the abrasive considerably, and can be used in combination with pigment pastes stabilized with the Anjeka series of additives. It can be used together with pigment pastes stabilized with Anjeka additives.

APPLICATION SECTORS

Industrial coatings ●

Automotive coatings ●

Coil coatings ●

Anti-corrosion coating systems●

●--Special Recommendations; ○--Recommendations

RECOMMENDED LEVELS

The amount of additives (in purchased form) is based on the pigment:

Inorganic pigments: 2%-5%

Titanium dioxide: 1%-3%

The above data are empirical, the optimum dosage should be determined by a series of tests.

INCORPORATION AND PROCESSING INSTRUCTIONS

In order to obtain the best performance, the additives should be added to the abrasive before the pigments.

PACKAGING

-25kg iron drum with inner coating

-180kg ring plastic drum

Our service:

Our team:

Our company:

Our Certifcate&Patents: